Detailed installation guide for Hi-Tide Boat Lift Controller

 

Into the receiver board terminal block, insert the labeled wires to the Raise (CH1), Lower (CH2), Common, 24VAC wires.  Wire the common from the Lift Mate power cord and the Limit Switch Sensor into the Common on the terminal block just below the transformer as shown.  The remaining wire(s) from the limit switch sensor can go into the upper and lower limit switch terminals as shown in the diagram.  For the Storage Position Sensor or the Lower Limit Switch Sensor to read properly, you must enable the Flip Sensor Logic toggle in the app configuration settings for the Storage or Lower Limit Sensor.