LiftMate wiring diagram for Hi-Tide Boat Lift Controller

WARNING: The Lift Mate Device Must Never Be Connected To Any Voltage Other Than 5-32VDC or 12-24VAC!

 See wiring diagram for Hi-Tide Boat Lift Controller below:

Disconnect power to the Lift by either unplugging the lift or shutting off the breaker.  Into the receiver board terminal block, insert the blue, purple, and black wires to the Raise (CH1 NO), Lower (CH2 NO), & Common on the receiver board per the diagram above. Connect the red wire of the power cable into the 24VAC (+) wire in the terminal block under the low voltage transformer, per the diagram, using the provided T-Tap connector.  Wire the black common from the Lift Mate power cord and the Limit Switch Sensor (if your boat lift has limit switches) into the Common on the white terminal block, just below the transformer as shown above, using the provided T-Tap connector.  The remaining wire(s) from the limit switch sensor (if boat lift has limit switches) can go into the upper and lower limit switch terminals as shown in the diagram.  For the Storage Position Sensor or the Lower Limit Switch Sensor to read properly, you must enable the Flip Sensor Logic toggle in the app configuration settings for the Storage or Lower Limit Sensor.

If you have any questions, please feel free to contact us at support@lift-mate.com